Festool SYS-AZ Layout Tool

If you have a lot of Festool Systainer boxes then at some point you may wish to purchase some of the Festool SYS-AZ drawers and build yourself some pull out drawer units. All of the normal sized systainers (all generations) fit in these drawers, the XL ones don't as they're too wide.

They are built using 32mm cabinetry techniques and Instructions are included with the drawers however what I found tricky when I built mine was working out what I would actually be able to fit in a unit of a particular size so I wrote this tool to help. You can enter your dimensions and then plan out what will fit within your intended unit.

This can change later on of course but I think it makes for a good starting point as the units fill up faster than you might imagine if you're putting larger systainers in them.

Input

Model Height (mm) Increase (mm) Offset

** this is shown as 7 in the manual for some reason, 6 works in reality

Errors

Output